Closing your pool
Don't know how to close your pool for the winter? Sima Ste-Marie will guide you through the entire process. In just a few steps, you'll be able to properly winterize your pool.
An explanatory video about above-ground and in-ground pools is presented a little further down.
Properly closing your pool protects it from winter damage while making it easier to reopen in the spring.
When is the best time to close the pool? As late as possible! The ideal time is generally between late September and early November. It is best to wait until the water has reached approximately 10 °C (50 °F). It is very important to continue filtering the pool water at all times until it is closed.
Here are the recommended steps for closing a pool:
1. One week before closing the pool, clean the sand filter or cartridge filter. Balance the water to achieve a pH of 7.6 and a total alkalinity of 120 ppm.
2. Remove the solar cover and clean it.
3. Using a leaf rake, remove all debris accumulated at the bottom of the pool. If necessary, use the vacuum in drain or waste mode (if applicable, the valve under the skimmer must be set to 100% skimmer and suction only at the skimmer if your pool is equipped with a main drain).
4. Lower the water level until the waterline is between 30 and 40 cm (12 and 16 in) below the return jets. To do this, use the vacuum or the main drain (by selecting 100% main drain suction on the valve under the skimmer).
5. Remove the pool ladder or stairs from the pool.
6. Clean the waterline, skimmer, ladder, or stairs.
7. Remove the door, skimmer basket, and return eye.
8. Move the handle of the valve under your skimmer so that water cannot flow out of the pool, normally where the skimmer-to-pump hose is connected. Disconnect the hoses connecting the skimmer to the pump, the pump to the filter, and the filter to the return.
9. If your pool is equipped with one, disconnect the heater and your sanitation system.
10. Disconnect the hose connecting the main drain to the three-way valve, attach the extension hose, and secure everything firmly to a stake or the edge of your pool. Pour antifreeze into this hose.
11. For an in-ground pool, you will need to remove the water from the plumbing using a wet/dry vacuum.
12. Insert a pool noodle to protect the main drain hose. Fold the end of the noodle so that it stays wedged in the hose opening.
13. Insert a block of Styrofoam into the skimmer and screw a cap onto the return.
14. Drain the pump and store it indoors, away from freezing temperatures, during the winter.
15. Remove the plug from your filter drain to empty the water. Store this plug in the pump basket so you can easily find it in the spring. Set the filter head to the winter position.
16. Remove the following items from the filter: the pressure gauge, the hose clamp for the drain hose, the sight glass, and the seals. Store these items in the pump basket. It is highly recommended to apply lubricant to the seals (O-rings).
17. If your pool has a salt chlorination system, disconnect the cell, clean it, and store it away from freezing temperatures. Remove and store the control panel if possible. Also disconnect and store your UV systems and chlorinator if required.
18. If the pool is equipped with a light in the skimmer or return, remove it.
19. If you have a heat pump, unscrew the plumbing and, using a wet/dry vacuum, remove the remaining water from the heater. Cover the heat pump with a protective cover.
20. Add the contents of the closing kit.
21. We recommend covering the pool with an elastic system and a winter net to make it easier to clean in the spring. This will also protect your pool liner from the sun's rays.