Closing your spa
Have you decided to close your spa for the winter? Here are a few tips to follow for a smooth process.
An explanatory video is presented a little further down.
Sima spas are designed for year-round use. In fact, one of the great joys of having a spa is being able to enjoy it in winter too! Did you know that keeping your spa running throughout the four seasons reduces the risk of damage?
If you close your spa for the winter, you must be very thorough; no water must remain in the plumbing. There are several steps to follow when closing a spa for the winter.
As closing a spa takes one to two days, we recommend ideally planning it when the temperature is still above 0°C to avoid any disaster (frozen components, damage to the spa, etc.). Do not wait past mid-November if you are located in southwestern Quebec, and the end of October if you live near Quebec City or further north.
Cleaning and rinsing the spa is recommended before starting the draining process to prevent the accumulation of limescale and elements that are corrosive or harmful to the spa components (pump, heater, seals, etc.). There are products that clean the plumbing, such as the Calypso Cal Check Plus # 28 descaler, which also destroy accumulated biofilm. Carefully follow all the steps as indicated in the instructions.
You must then drain your spa:
1) Lower the thermostat of your spa and allow the water time to cool. Remove the cover and run the pump at high speed until the water has cooled.
2) Turn off the power to the spa.
3) Attach a garden hose of appropriate size to the drain connection and place the other end of the hose in a suitable place to receive the dirty water.
4) Once the drain valve is open, the spa drains by gravity and requires no supervision. To speed up the draining, you can use a submersible pump that you will find in most hardware stores.
5) During draining, move the water around the seats toward the bottom of the spa.
6) Remove the remaining water with a shop vac, a sponge, and a bucket. It is important to vacuum the water out of all orifices (suction, jets, cartridge holder, etc.)
7) Clean the surface or waterline as needed.
8) Close the drain valve before adding antifreeze to protect the plumbing.
The filter cartridge or cartridges must be removed. Add antifreeze to protect the plumbing. Clean the cartridge or cartridges. Remove the larger debris with a jet of water. Soak in a solution containing a cartridge-specific cleaner (Calypso Filter Cleaner #7) to remove contaminants. Rinse the cartridge thoroughly to remove the product. Let it dry. Store it with the cartridge holders if you have them with your spa.
Finally, insert your rigid spa cover and cover it with a cover or tarp to prevent water from seeping in. It is important to use a block of styrofoam that will support your cover to prevent it from sagging in case of snow accumulation. You can also use a 2 in x 4 in board along the center hinge.
There, your spa is now properly winterized until spring!