Votre piscine a un problème de pression? Détection et solutions

SWIMMING POOLS

Is your pool water cloudy or the pressure from its jets abnormal? You may be facing a pool pressure problem. In this article, we will guide you through detecting the cause of this pressure imbalance and show you how to easily resolve it.

How to detect a pressure problem

To start, check your return jets. If they have lower pressure, it is very likely that a pressure problem is causing the imbalance in your pool.

What could cause a pressure problem in a pool?

Several factors can cause a pressure problem in your pool. The best indicator is your pressure gauge. This small round dial with a needle is used to ensure that water is circulating properly through your filter. It will indicate the water pressure in PSI or bar.

Good to know: To determine your pool's normal pressure, make sure your filtration system is in perfect condition (clean sand, new or freshly cleaned cartridge). Then, note the reading on your pressure gauge: this is your baseline pressure.

There are two possibilities: the problem is either at the outlet or before the pump.

If the pressure gauge reading is higher than normal, the problem is after the pump:

  • A cartridge clogged with debris.
  • Filter sand clogged with debris.
  • A closed valve.
  • A plug left in the return jet when opening the pool.

If the pressure gauge reading is lower than normal, the problem is before the pump:

  • Leaves on the main drain (you should see suction at this drain)
  • Leaves in the skimmer basket or pump basket.
  • Debris in the motor's impeller.
  • A closed valve.
  • A leak.

If your pressure gauge reads zero:
This means it is no longer working. It no longer indicates the pressure, but it does not cause a pressure problem in your pool itself. Try tapping on it or turning the pump off and back on. If it remains at zero, it is no longer working and must be replaced.

How to fix your pool's pressure problem

If the pressure gauge reading is high:

  • Check if the return jet plug is still in place.
  • If you have a sand filter, backwash it and clean the sand with the appropriate product. If the problem persists, your sand may need to be replaced.
  • If you have a cartridge filter, clean it with a product designed for this purpose. If the problem persists, your cartridge may need to be replaced.
  • Make sure all valves are properly open.

If the pressure gauge reading is low:

  • Check your pool's water level and adjust it if necessary.
  • Make sure there is no air in the pool pump and that it is properly filled. Some pumps must be primed by filling them with water.
  • Empty and clean the skimmer and pool pump baskets.
  • Remove leaves from the main drain or set the circulation to skimmer only if you have a lot of debris at the bottom of the pool.
  • Make sure your pump lid or connection unions (rings) on the plumbing are properly tightened.
  • Make sure the multiport valve is properly open to allow water to circulate toward the pump.