Piscines hors terre | Les étapes de la fermeture pour l’hiver!

Above-ground pools | The steps for winterizing your pool!

Properly closing your pool helps protect it from winter damage while making it easier to reopen in the spring.

When is the best time to close the pool? As late as possible! The ideal time is generally between late September and early November. It is best to wait until the water has reached approximately 10°C (50°F). It is very important to continue filtering the pool water at all times until it is closed.

Here are the recommended steps for closing a pool:

1. One week before closing the pool, clean the sand or cartridge filter. Balance the water to achieve a pH of 7.6 and a total alkalinity of 120 ppm.

2. Remove the solar cover and clean it.

3. Using a leaf rake, remove all debris accumulated at the bottom of the pool. If necessary, use the pool vacuum in drain or waste mode (if applicable, the valve under the skimmer must be set to 100% skimmer – suction only through the skimmer if your pool is equipped with a main drain).

4. Lower the water level until the waterline is between 30 and 40 cm (12 and 16 in) below the return jets. To do this, use the pool vacuum or the main drain (by selecting 100% main drain suction on the valve under the skimmer).

5. Remove the pool ladder and steps.

6. Clean the waterline, skimmer, ladder, and steps.

7. Remove the door, skimmer basket, and return jet eye.

8. Disconnect the hoses connecting the skimmer to the pump, the pump to the filter, and the filter to the return jet.

9. If your pool is equipped with one, disconnect the heater and salt chlorine generator.

10. Disconnect the hose connecting the main drain to the three-way valve, connect the extension hose, and secure everything firmly to a stake or the edge of your pool. Pour antifreeze into this hose.

11. Insert a pool noodle to protect the main drain hose. Fold the end of the pool noodle so that it stays wedged in the hose opening.

12. Insert a block of styrofoam into the skimmer and screw a cap onto the return jet.

13. Drain the pump and store it indoors, away from freezing temperatures, during the winter.

14. Remove the plug from the filter drain. Store this plug in the pump basket so that it is easy to find when spring arrives.

15. Remove the following items from the filter: the pressure gauge, the hose clamp for the drain hose, the sight glass, and the O-rings. Store these items in the pump basket. It is highly recommended to apply lubricant to the O-rings.

16. If your pool has a salt chlorination system, disconnect the cell, clean it, and store it away from freezing temperatures. Remove and store the control panel if possible.

17. If the pool is equipped with a light in the skimmer or return jet, remove it.

18. If you have a heat pump, unscrew the plumbing and, using a wet/dry vacuum or leaf vacuum, drain the remaining water from the heater. Cover the heat pump with a protective cover.

19. Add the contents of the closing kit.

20. We recommend covering the pool with an elastic cover system and a winter net to make it easier to clean in the spring. This will also protect your pool liner from the sun's rays.

Questions?

Our experts can help! They can explain this process in more detail, as it may vary depending on your pool's model and installation, and advise you on the right products to use.

Short on time? We offer a pool closing service. Our specialists will perform a high-quality closing that perfectly meets your needs. Request your pool closing now in the services tab!